AudioCodes Mediant 500L - Page 237

Version 7.2 237 Mediant 500L Gateway & E-SBC
User's Manual 15. Services
4. Click Apply, and then save your settings to flash memory.
Table 15-6: SIP Recording Rules Table Parameter Descriptions
Parameter Description
General
Index
[SIPRecRouting_Index]
Defines an index number for the new table record.
Recorded IP Group
recorded-ip-group-name
[SIPRecRouting_RecordedIPGro
upName]
Defines the IP Group participating in the call and the recording is
done on the leg interfacing with this IP Group. To configure IP
Groups, see ''Configuring IP Groups'' on page 363.
By default, all IP Groups are defined (Any).
Note:
 The parameter is mandatory.
 For an SBC RTP-SRTP session, the recorded IP Group must
be set to the RTP leg if recording is required to be RTP, or set
to the SRTP leg if recording is required to be SRTP.
Recorded Source Prefix
recorded-src-prefix
[SIPRecRouting_RecordedSourc
ePrefix]
Defines calls to record based on source number or URI.
By default, all source numbers or URIs are defined (*).
Recorded Destination Prefix
recorded-dst-prefix
[SIPRecRouting_RecordedDestin
ationPrefix]
Defines calls to record based on destination number or URI.
By default, all destination numbers or URIs are defined (*).
Condition
condition-name
[SIPRecRouting_ConditionName]
Assigns a Message Condition rule to the SIP Recording rule to
base the start of call recording on a specific condition. To
configure Message Condition rules, see "Configuring Message
Condition Rules" on page 421. For more information on using
conditions with SIPRec, see "Using Conditions for SIPRec
Sessions" on page 238.
Peer IP Group
peer-ip-group-name
[SIPRecRouting_PeerIPGroupNa
me]
Defines the peer IP Group that is participating in the call.
By default, all IP Groups are defined (Any).
Peer Trunk Group ID
peer-trunk-group-id
[SIPRecRouting_PeerTrunkGrou
pID]
Defines the peer Trunk Group that is participating in the call
(applicable only to Gateway calls). To configure Trunk Groups,
see Configuring Trunk Groups on page 501.
Caller
caller
[SIPRecRouting_Caller]
Defines which calls to record according to which party is the
caller.
 [0] Both = (Default) Caller can be peer or recorded side
 [1] Recorded Party (in Gateway, IP-to-Tel call)
 [2] Peer Party (in Gateway, Tel-to-IP call)
Recording Server
Recording Server (SRS) IP
Group
Defines the IP Group of the recording server (SRS).
By default, no value is defined..