AudioCodes Mediant 500L - Page 253

Version 7.2 253 Mediant 500L Gateway & E-SBC
User's Manual 15. Services
The following procedure describes how to configure an LDAP server through the Web
interface. You can also configure it through ini file (LdapConfiguration) or CLI (configure
system > ldap ldap-configuration).
Note: When you configure an LDAP server, you need to assign it an LDAP Server
Group. Therefore, before you can configure an LDAP server in the table, you must
first configure at least one LDAP Server Group in the LDAP Server Groups table (see
''Configuring LDAP Server Groups'' on page 250).
 To configure an LDAP server:
1. Open the LDAP Servers table (Setup menu > IP Network tab > RADIUS & LDAP
folder > LDAP Servers).
2. Click New; the following dialog box appears:
Figure 15-22: LDAP Servers Table - Add Dialog Box
3. Configure an LDAP server according to the parameters described in the table below.
4. Click Apply.
Table 15-9: LDAP Servers Table Parameter Descriptions
Parameter Description
General
Index
[LdapConfiguration_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
LDAP Servers Group
server-group
[LdapConfiguration_Group]
Assigns the LDAP server to an LDAP Server Group, configured in
the LDAP Server Groups table (see ''Configuring LDAP Server
Groups'' on page 250).
Note:

The parameter is mandatory and must be set before configuring