AudioCodes Mediant 500L - Page 288

User's Manual 288 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Table 15-20: HTTP Remote Hosts Table Parameter Descriptions
Parameter Description
Index
rest-servers
[HTTPRemoteHosts_Remote
Hostindex]
Defines an index number for the new table row.
Note:
 Each row must be configured with a unique index.
 The parameter is mandatory.
Name
[HTTPRemoteHosts_Name]
Defines a descriptive name, which is used when associating the row
in other tables.
The valid value is a string of up to 40 characters. By default, no value
is defined.
Note:
 Each row must be configured with a unique name.
 The parameter is mandatory.
Address
rest-address
[HTTPRemoteHosts_Address]
Defines the address (IP address or FQDN) of the remote host.
The valid value is a string of up to 80 characters.
Note:
 An IPv6 address can only be configured if the interface is a
CONTROL type.
 If the address is an FQDN and the DNS resolution results in
multiple IP addresses, the device device attempts to establish
multiple connections (sessions) for each IP address. Only the first
10 resolved IP addresses are used regardless of the number of
hosts.
 FQDN resolution is also performed (immediately) when
connection is subsequently "closed" (by timeout or by the remote
host) and connections are updated accordingly. In addition, the
device periodically (every 15 minutes) performs DNS name
resolution to ensure that the list of resolved IP addresses has not
changed. If a change is detected, the device updates its' list of IP
addresses and re-establishes connections accordingly.
 In addition to multiple HTTP sessions, the device establishes
multiple (TCP) connections per session, thereby enhancing data
exchange capabilities with the host.
Port
rest-port
[HTTPRemoteHosts_Port]
Defines the port of the host.
The valid value is 0 to 65535. The default is 80.
Interface
rest-interface
[HTTPRemoteHosts_Interface
]
Assigns one of the device's IP network interfaces through which
communication with the remote host is done.
By default, no value is defined and the OAMP interface is used.
Transport Type
rest-transport-type
[HTTPRemoteHosts_HTTPTr
ansportType]
Defines the protocol for communicating with the remote host:
 [0] HTTP (default)
 [1] HTTPS
Status
http-host-state
(Read-only) Displays the status of the connection with the remote
host.
 "Connected": The hosts is connected.
 "Disconnected": The host is disconnected.