Version 7.2 327 Mediant 500L Gateway & E-SBC
User's Manual 16. Quality of Experience
to the destination IP Group or use an alternative IP Profile for the IP Group. For more
information, see ''Configuring Quality of Service Rules'' on page 334.
Alternative routing based on measured metrics. If a call is rejected because of a
crossed threshold, the device generates a SIP 806 response. You can configure this
SIP response code as a reason for alternative routing (see ''Configuring SIP
Response Codes for Alternative Routing Reasons'' on page
703).
Note: For your convenience, the device provides pre-
Experience Profiles. One of these pre-configured profiles is the default Quality of
Experience Profile, which is used if you do not configure a Quality of Experience
Profile.
The following procedure describes how to configure Quality of Experience Profiles through
the Web interface. You can also configure it through other management platforms:
Quality of Experience Profile table: ini file (QoEProfile) or CLI (configure voip > qoe
qoe-profile)
Quality of Experience Color Rules table: ini file (QOEColorRules) or CLI (configure
voip > qoe qoe-color-rules)
To configure a QoE Profile:
1. Open the Quality of Experience Profile table (Setup menu > Signaling & Media tab >
Media folder > Quality of Experience > Quality of Experience Profile).
2. Click New; the following dialog box appears:
Figure 16-3: Quality of Experience Profile Table - Dialog Box
3. Configure a QoE Profile according to the parameters described in the table below.
4. Click Apply.
Table 16-2: Quality of Experience Profile Table Parameter Descriptions
Parameter Description
Index
[QOEProfile_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Profile Name
name
[QOEProfile_Name]
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value is a string of up to 20 characters.
To Next Page
Loading...
