AudioCodes Mediant 500L - Page 332

User's Manual 332 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Threshold Crossing Calculation
Threshold based on
Example
cleared)
hysteresis.
64,000)]
Red to Green (alarm cleared) The change occurs if the current bandwidth
crosses the configured Minor threshold with
hysteresis.
25,600 Kbps
[32,000 - (10% x
64,000)]
The following procedure describes how to configure Bandwidth Profiles through the Web
interface. You can also configure it through ini file (BWProfile) or CLI (configure voip > qoe
bw-profile).
 To configure a Bandwidth Profile:
1. Open the Bandwidth Profile table (Setup menu > Signaling & Media tab > Media
folder > Quality of Experience > Bandwidth Profile).
2. Click New; the following dialog box appears:
Figure 16-6: Bandwidth Profile Table - Dialog Box
3. Configure a rule according to the parameters described in the table below.
4. Click Apply, and then reset the device with a save to flash memory.
Table 16-5: Bandwidth Profile Table Parameter Descriptions
Parameter Description
General
Index
[BWProfile_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
name
[BWProfile_Name]
Defines a descriptive name, which is used when associating
the row in other tables.
The valid value is a string of up to 20 characters.
Egress Audio Bandwidth
egress-audio-bandwidth
[BWProfile_EgressAudioBandwidth]
Defines the major (total) threshold for outgoing audio traffic (in
Kbps).
Ingress Audio Bandwidth
ingress-audio-bandwidth
Defines the major (total) threshold for incoming audio traffic (in
Kbps).