User's Manual 342 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
3. Click New; the following dialog box appears:
Figure 17-3: Remote Media Subnet Table - Add Dialog Box
4. Configure the Remote Media Subnet according to the parameters described in the
table below.
5. Click Apply.
Table 17-2: Remote Media Subnet Table Parameter Descriptions
Parameter Description
Index
[RemoteMediaSubnet_RemoteMediaS
ubnetIndex]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
name
[RemoteMediaSubnet_RemoteMediaS
ubnetName]
Defines a descriptive name, which is used when associating
the row in other tables.
The valid value is a string of up to 20 characters.
Note: Each row must be configured with a unique name.
Prefix Length
prefix-length
[RemoteMediaSubnet_PrefixLength]
Defines the subnet mask in Classless Inter-Domain Routing
(CIDR) notation. For example, 16 denotes 255.255.0.0.
The default is 16.
Address Family
address-family
[RemoteMediaSubnet_AddressFamily]
Defines the IP address protocol.
[2] IPv4 (default)
[10] IPv6
Destination IP
dst-ip-address
[RemoteMediaSubnet_DstIPAddress]
Defines the IP address of the destination.
The default is 0.0.0.0.
QoE Profile
qoe-profile
[RemoteMediaSubnet_QOEProfileNa
me]
Assigns a Quality of Experience Profile to the Remote Media
Subnet.
By default, no value is defined.
To configure QoE Profiles, see ''Configuring Quality of
Experience Profiles'' on page 325.
To Next Page
Loading...
