AudioCodes Mediant 500L - Page 349

Version 7.2 349 Mediant 500L Gateway & E-SBC
User's Manual 17. Control Network
Parameter Description
[SRD_SBCRoutingPolicyName]
Routing Policies. If you have configured only one Routing Policy,
the device assigns it to the SRD by default.
For more information on Routing Policies, see Configuring SBC
Routing Policy Rules on page 705.
Note:
 If you have assigned a Routing Policy to a Classification rule
that is associated with the SRD, the Routing Policy assigned to
the SRD is ignored.
 You can assign the same Routing Policy to multiple SRDs.
 The parameter is applicable only to the SBC application.
Used By Routing Server
used-by-routing-server
[SRD_UsedByRoutingServer]
Enables the SRD to be used by a third-party routing server for call
routing decisions.
 [0] Not Used (default)
 [1] Used
For more information on the third-party routing server feature, see
''Centralized Third-Party Routing Server'' on page 289.
Dial Plan
sbc-dial-plan-name
[SRD_SBCDialPlanName]
Assigns a Dial Plan to the SRD
. The device searches the Dial Plan
for a dial plan rule that matches the source number and if not
found, for a rule that matches the destination number. If a
matching dial plan rule is found, the rule's tag is used in t
he routing
and/or manipulation processes as source and/or destination tags.
To configure Dial Plans, see Configuring Dial Plans on page 726.
Registration
Max. Number of Registered
Users
max-reg-users
[SRD_MaxNumOfRegUsers]
Defines the maximum number of users belonging to the SRD that
can register with the device.
The default is -1, which means that the number of allowed user
registrations is unlimited.
Note: The parameter is applicable only to the SBC application.
User Security Mode
block-un-reg-users
[SRD_BlockUnRegUsers]
Defines the blocking (reject) policy for incoming SIP dialog-
initiating requests (e.g., INVITE messages) from registered and
unregistered users belonging to the SRD.
 [0] Accept All = (Default) Accepts requests from registered and
unregistered users.
 [1] Accept Registered Users = Accepts requests only from
users registered with the device. Requests from users not
registered are rejected.
 [2] Accept Registered Users from Same Source = Accepts
requests only from registered users whose source address is
the same as that registered with the device (during the
REGISTER message process). All other requests are rejected.
If the transport protocol is UDP, the device verifies the IP
address and port; otherwise, it verifies only the IP address. The
verification is performed before any of the device's call handling
processes (i.e., Classification, Manipulation and Routing).
Note:
 The parameter is applicable only to calls belonging to User-
type IP Groups.
 The feature is not applicable to REGISTER requests.