AudioCodes Mediant 500L - Page 387

Version 7.2 387 Mediant 500L Gateway & E-SBC
User's Manual 17. Control Network
Parameter Description
Proxy Address
proxy-address
[ProxyIp_IpAddress]
Defines the address of the proxy.
Up to 10 addresses can be configured per Proxy Set. The address
can be defined as an IP address in dotted-decimal notation (e.g.,
201.10.8.1) or FQDN. You can also specify the port using the
following format:
 IPv4 address: <IP address>:<port> (e.g., 201.10.8.1:5060)
 IPv6 address: <[IPV6 address]>:<port> (e.g.,
[2000::1:200:200:86:14]:5060)
Note:
 When configured with an FQDN, you can configure the periodic
rate at which the device performs DNS queries to resolve the
FQDN into IP addresses. For more information, see the
ProxyIPListRefreshTime parameter.
 When configured with an FQDN, you can configure the method
(e.g., A-record) for resolving the domain name into an IP
address, using the 'DNS Resolve Method' parameter in this
table (see above).
 The device supports up to 30 DNS-resolved IP addresses. If the
DNS resolution provides more than this number, the device
uses the first 30 IP addresses in the received list and ignores
the rest.
 For the SBC application: You can configure the device to use
the port indicated in the Request-URI of the incoming message,
instead of the port configured for the parameter. To enable this,
use the IPGroup_SBCRouteUsingRequestURIPort parameter
for the IP Group that is associated with the Proxy Set
(Configuring IP Groups on page 363).
Transport Type
transport-type
[ProxyIp_TransportType]
Defines the transport type for communicating with the proxy.
 [0] UDP
 [1] TCP
 [2] TLS
 [-1] = (Default) The transport type is according to the settings of
the global parameter, SIPTransportType.