AudioCodes Mediant 500L - Page 397

Version 7.2 397 Mediant 500L Gateway & E-SBC
User's Manual 18. SIP Definitions
Parameter Description
application.
General
Index Defines an index for the new table row.
Note: Each row must be configured with a unique index.
Application Type
application-type
[Account_ApplicationType]
Defines the application type:
 [0] GW = (Default) Gateway application.
 [2] SBC = SBC application.
Served IP Group
served-ip-group-name
[Account_ServedIPGroupName]
Defines the IP Group (e.g., IP-PBX) that you want to
register and/or authenticate upon its behalf.
Note:
 The parameter is applicable only to the SBC
application.
 By default, all IP Groups are displayed. However, if
you filter the Web display by SRD (using the SRD
Filter box), only IP Groups associated with the filtered
SRD are displayed.
Serving IP Group
serving-ip-group-name
[Account_ServingIPGroupName]
Defines the IP Group (Serving IP Group) to where the
device sends the SIP REGISTER requests (if enabled)
for registration and authentication (of the Served IP
Group).
 Tel-to-IP calls: The serving IP Group is the
destination IP Group configured in the Trunk Group
Settings table or Tel-to-IP Routing table (see
Configuring Tel-to-IP Routing Rules on page 509).
 IP-to-Tel calls: The serving IP Group is the 'Source IP
Group ID' configured in the IP-to-Tel Routing table
(see Configuring IP-to-Tel Routing Rules on page
518).
Note:

By default, only IP Groups associated with the SRD to
which the Served IP Group is associated are
displayed, as well as IP Groups of Shared SRDs.
However, if you filter the Web display by SRD (using
the SRD Filter box), only IP Groups associated with
the filtered SRD are displayed, as well as IP Groups
of Shared SRDs.
 The parameter is mandatory.
Host Name
host-name
[Account_HostName]
Defines the Address of Record (AOR) host name. The
host name appears in SIP REGISTER From/To headers
as ContactUser@HostName. For a successful
registration, the host name is also included in the URI of
the INVITE From header.
The valid value is a string of up to 49 characters.
Note: If the parameter is not configured or if registration
fails, the 'SIP Group Name' parameter value configured
in the IP Groups table is used instead.
Register
register
Enables registration.
 [0] No= (Default) The device only performs