AudioCodes Mediant 500L - Page 407

Version 7.2 407 Mediant 500L Gateway & E-SBC
User's Manual 18. SIP Definitions

Correct:
• Single rule:
Condition: ldap.found !exists Action Type: Exit Action Value: False
• Set of rules:
Condition: ldap.found exists Action Type: Exit Action Value: True
Condition: <leave it blank> Action Type: Exit Action Value: False
Note: If the source and/or destination numbers are manipulated by the Call Setup
rules, they revert to their original values if the device moves to the next routing rule.
The following procedure describes how to configure Call Setup Rules through the Web
interface. You can also configure it through ini file (CallSetupRules) or CLI (configure voip >
message call-setup-rules).
 To configure a Call Setup rule:
1. Open the Call Setup Rules table (Setup menu > Signaling & Media tab > SIP
Definitions folder > Call Setup Rules).
2. Click New; the following dialog box appears:
Figure 18-1: Call Setup Rules Table - Add Dialog Box
3. Configure a Call Setup rule according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Table 18-2: Call Setup Rules Parameter Descriptions
Parameter Description
General
Index
[CallSetupRules_Index]
Defines an index number for the new table record.
Note: Each rule must be configured with a unique index.
Rules Set ID
rules-set-id
Defines a Set ID for the rule. You can define the same Set ID
for multiple rules to create a group of rules. You can configure
up to 10 Set IDs, where each Set ID can include up to 10 rules.