Version 7.2 411 Mediant 500L Gateway & E-SBC
User's Manual 18. SIP Definitions
call's source number with a number retrieved from the AD by an LDAP query. The
device queries the AD server for the attribute record, "telephoneNumber" whose value
is the same as the received source number (e.g., "telephoneNumber =4064"). If such
an attribute is found, the device retrieves the number of the attribute record,
"alternateNumber" and uses this number as the source number.
• Call Setup Rules table configuration:
♦ 'Rules Set ID': 1
♦ 'Query Type': LDAP
♦ 'Query Target': LDAP-DC-CORP
♦ 'Search Key': ‘telephoneNumber=’ + param.call.src.user
♦ 'Attributes to Get': alternateNumber
♦ 'Row Role': Use Current Condition
♦ 'Condition': ldap.attr. alternateNumber exists
♦ 'Action Subject': param.call.src.user
♦ 'Action Type': Modify
♦ 'Action Value': ldap.attr. alternateNumber
• Routing table configuration: A single routing rule is assigned the Call Setup
Rule Set ID.
♦ Index 1:
'Call Setup Rules Set ID': 1
Example 2: This example configures the device to replace (manipulate) the incoming
call's calling name (caller ID) with a name retrieved from the AD by an LDAP query.
The device queries the AD server for the attribute record, "telephoneNumber" whose
value is the same as the received source number (e.g., "telephoneNumber =5098"). If
such an attribute is found, the device retrieves the name from the attribute record,
"displayName" and uses this as the calling name in the incoming call.
• Call Setup Rules table configuration:
♦ 'Rules Set ID': 2
♦ 'Query Type': LDAP
♦ 'Query Target': LDAP-DC-CORP
♦ 'Search Key': ‘telephoneNumber=’ + param.call.src.user
♦ 'Attributes to Get': displayName
♦ 'Row Role': Use Current Condition
♦ 'Condition': ldap.attr. displayName exists
♦ 'Action Subject': param.call.src.name
♦ 'Action Type': Modify
♦ 'Action Value': ldap.attr. displayName
• Routing table configuration: A single routing rule is assigned the Call Setup
Rule Set ID.
♦ Index 1:
'Call Setup Rules Set ID': 2
Example 3: This example configures the device to route the incoming call according
to whether or not the source number of the incoming call also exists in the AD server.
The device queries the AD server for the attribute record, "telephoneNumber" whose
value is the same as the received source number (e.g., telephoneNumber=4064"). If
such an attribute is found, the device sends the call to Skype for Business; if the query
fails, the device sends the call to the PBX.
• Call Setup Rules table configuration:
♦ 'Rules Set ID': 3
To Next Page
Loading...
