AudioCodes Mediant 500L - Page 419

Version 7.2 419 Mediant 500L Gateway & E-SBC
User's Manual 19. SIP Message Manipulation
3. Configure a Message Manipulation rule according to the parameters described in the
table below.
4. Click Apply.
An example of configured message manipulation rules are shown in the figure below:
Figure 19-4: Example of Configured Message Manipulation Rules

Index 0: Adds the suffix ".com" to the host part of the To header.

Index 1: Changes the user part of the From header to the user part of the P-Asserted-
ID.

Index 2: Changes the user part of the SIP From header to "200".

Index 3: If the user part of the From header equals "unknown", then it is changed
according to the srcIPGroup call’s parameter.

Index 4: Removes the Priority header from an incoming INVITE message.
Table 19-1: Message Manipulations Parameter Descriptions
Parameter Description
General
Index
[MessageManipulations_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
manipulation-name
[MessageManipulations_Manip
ulationName]
Defines an arbitrary name to easily identify the rule.
The valid value is a string of up to 16 characters.
Manipulation Set ID
manipulation-set-id
[MessageManipulations_ManSe
tID]
Defines a Manipulation Set ID for the rule. You can define the
same Manipulation Set ID for multiple rules to create a group of
rules. The Manipulation Set ID is used to assign the manipulation
rules to an IP Group (in the IP Groups table) for inbound and/or
outbound messages.
The valid value is 0 to 19. The default is 0.
Row Role
row-role
[MessageManipulations_RowR
ole]
Determines which message manipulation condition (configured by
the 'Condition' parameter) to use for the rule.
 [0] Use Current Condition = (Default) The condition configured
in the table row of the rule is used.
 [1] Use Previous Condition = The condition configured in the
first table row above the rule that is configured to Use Current
Condition is used. For example, if Index 3 is configured to Use
Current Condition and Index 4 and 5 are configured to Use
Previous Condition, Index 4 and 5 use the condition
configured for Index 3. A configuration example is shown in the
beginning of this section. The option allows you to use the same
condition for multiple manipulation rules.
Note: