AudioCodes Mediant 500L - Page 481

Version 7.2 481 Mediant 500L Gateway & E-SBC
User's Manual 20. Coders and Profiles
Parameter Description
For more information on echo cancellation, see ''Configuring
Echo Cancellation'' on page 185.
Note: The corresponding global parameter is
EnableEchoCanceller.
EC NLP Mode
echo-canceller-nlp-mode
[TelProfile_ECNlpMode]
Enables Non-Linear Processing (NLP) mode for echo
cancellation.
 [0] Adaptive NLP = (Default) NLP adapts according to
echo changes
 [1] Disable NLP
Note: The corresponding global parameter is ECNLPMode.
Jitter Buffer
Dynamic Jitter Buffer Minimum
Delay
jitter-buffer-minimum-delay
[TelProfile_JitterBufMinDelay]
Defines the minimum delay (in msec) of the device's dynamic
Jitter Buffer.
The valid range is 0 to 150. The default delay is 10.
For more information on Jitter Buffer, see ''Configuring the
Dynamic Jitter Buffer'' on page 200.
Note: The corresponding global parameter is DJBufMinDelay.
Dynamic Jitter Buffer Maximum
Delay
jitter-buffer-maximum-delay
[TelProfile_JitterBufMaxDelay]
Defines the maximum delay (in msec) for the device's
Dynamic Jitter Buffer.
The default is 300.
Dynamic Jitter Buffer Optimization
Factor
jitter-buffer-optimization-factor
[TelProfile_JitterBufOptFactor]
Defines the Dynamic Jitter Buffer frame error/delay
optimization factor.
The valid range is 0 to 12. The default factor is 10.
For more information on Jitter Buffer, see ''Configuring the
Dynamic Jitter Buffer'' on page 200.
Note:
 For data (fax and modem) calls, configure the parameter
to 12.
 The corresponding global parameter is DJBufOptFactor.
Analog MWI
MWI Analog Lamp
mwi-analog-lamp
[TelProfile_MWIAnalog]
Enables the visual display of message waiting indications
(MWI).
 [0] Disable (default).
 [1] Enable = Enables visual MWI by supplying line voltage
of approximately 100 VDC to activate the phone's lamp.
Note:
 The parameter is applicable only to FXS interfaces.
 The corresponding global parameter is MWIAnalogLamp.
MWI Display
mwi-display
[TelProfile_MWIDisplay]
Enables sending MWI information to the phone display.
 [0] Disable = (Default) Does not send MWI information to
the phone's display.
 [1] Enable = The device generates an MWI message
(determined by the CallerIDType parameter), which is
displayed on the MWI display.