Version 7.2 55 Mediant 500L Gateway & E-SBC
User's Manual 6. Web-Based Management
device reset for your changes to take effect. When you change such a parameter and
then click Apply, the Reset button on the toolbar is encircled by a red border. If you
click the button, the Maintenance Actions page opens, which provides commands for
doing this (see ''Basic Maintenance'' on page 779).
Typically required parameters are displayed in bold font.
If you enter an invalid value for a parameter and then click Apply, a message box
appears notifying you of the invalid value. Click OK to close the message. The
parameter reverts to its previous value and the field is surrounded by a colored border,
as shown in the figure below:
To get help on a parameter, simply hover your mouse over the parameter's field and a
pop-up help appears, displaying a brief description of the parameter.
The following procedure describes how to configure stand-alone parameters.
To configure a stand-alone parameter:
1. Modify the parameter's value as desired.
2. Click Apply; the changes are saved to the device's volatile memory (RAM).
3. Save the changes to the device's non-volatile memory (flash):
• If a device reset is not required:
a. On the toolbar, click Save; a confirmation message box appears:
Figure 6-4: Save Configuration Confirmation Box
b. Click Yes to confirm; the changes are save to flash memory.
• If a device reset is required:
a. On the toolbar, click Reset; the Maintenance Actions page opens.
b. Click Reset; the device saves the changes to flash memory and then resets.
Warning: When you click Apply, your changes are saved only to the device's volatile
memory and thus, revert to their previous settings if the device later undergoes a
hardware reset, a software reset (without saving to flash) or powers down. Therefore,
make sure that you save your configuration to the device's flash memory.
To Next Page
Loading...
