AudioCodes Mediant 500L - Page 689

Version 7.2 689 Mediant 500L Gateway & E-SBC
User's Manual 35. Routing SBC
 To configure an IP-to-IP routing rule:
1. Open the IP-to-IP Routing table (Setup menu > Signaling & Media tab > SBC folder
> Routing > IP-to-IP Routing).
2. Click New; the following dialog box appears:
Figure 35-4: IP-to-IP Routing Table - Add Dialog Box
3. Configure an IP-to-IP routing rule according to the parameters described in the table
below.
4. Click Apply.
Table 35-2: IP-to-IP Routing Table Parameter Descriptions
Parameter Description
Routing Policy
sbc-routing-policy-name
[IP2IPRouting_RoutingPolicyN
ame]
Assigns a Routing Policy to the rule. The Routing Policy associates
the rule with an SRD(s). The Routing Policy also defines
default LCR
settings as well as the LDAP servers used if the routing rule is based
on LDAP routing (and Call Setup Rules).
If only one Routing Policy is configured in the Routing Policies table,
the Routing Policy is automatically assigned. If multiple Routing
Policies are configured, no value is assigned.
To configure Routing Policies, see ''Configuring SBC Routing Policy
Rules'' on page 705.
Note: The parameter is mandatory.
General
Index
[IP2IPRouting_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
route-name
[IP2IPRouting_RouteName]
Defines a descriptive name, which is used when associating the row
in other tables.
The valid value is a string of up to 40 characters.
By default, no value