AudioCodes Mediant 500L - Page 971

Version 7.2 971 Mediant 500L Gateway & E-SBC
User's Manual 60. Syslog and Debug Recording
Before running this command, the debug capture must be started.

Displays debug status and configured rules:
# debug capture VoIP physical show

Specifies the destination (FTP, TFTP, or USB) where you want the PCAP file sent:
# debug capture VoIP physical target <ftp|tftp|usb>

Stops the debug capture, creates a file named debug-capture-voip-<timestamp>.pcap,
and sends it to the TFTP or FTP server:
# debug capture voip physical stop <TFTP/FTP server IP
address>
If no IP address is defined, the capture is saved on the device for later retrieval.