Avaya PARTNER Advanced Communications System - Line Coverage Extension (#208)

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Line Coverage Extension (#208)
4-48
■ If you want to assign the line to a specific button, press 3. A display like the following
appears:
Line Assignment 15 L01
3 Select a Button
Then press a button with lights to assign the line to that button. If you use option 3 after a
line already has been assigned, the line moves from the old button to the new button you
select.
6. Do one of the following:
■ To program another line for this extension, press n or p until the line number
appears on the display. Then repeat Step 5.
■ To program another extension, press N P and begin at Step 2.
7. Select another procedure, or exit programming mode.
Line Coverage Extension (#208) 4
Use this feature to identify an extension as the “owner” of a specific outside line, so the extension
can activate Call Coverage or VMS Cover for that line.
Considerations 4
■ This feature applies only if you have a voice messaging system.
■ Only one owner can be assigned to a specific line. However, multiple lines can be owned by
the same extension.
■ This feature provides an alternative method of routing outside calls to the voice messaging
system for Call Answer Service.
■ This feature has no effect on the CO Line Ownership procedure in PARTNER Messaging,
PARTNER MAIL, PARTNER MAIL VS or the PARTNER Voice Messaging PC Card.
■ An extension’s “owned” line is eligible for coverage only if Line Ringing is set to Immediate
Ring or Delayed Ring and Line Access Restriction (#302) or Pool Access Restriction
(#315) is set to No Restriction or In Only.
■ Use Call Coverage to redirect an extension’s calls on owned lines to the covering extension.
■ Use Call Coverage Rings (#116) or (#320) to specify the number of times a call rings at the
owner’s extension before it is sent to the covering extension.
■ Use VMS Cover or Automatic VMS Cover (#310) to redirect the extension’s calls on owned
lines to the voice messaging system.
■ Use VMS Cover Rings (#117) or (#321) to specify the number of times a call rings at the
owner’s extension before it is sent to the voice messaging system.
■ To use Call Screening (F25), the station must be the Line Coverage Extension for that line.