Avaya PARTNER Advanced Communications System - Vms Hunt Schedule

Using Auxiliary Equipment
Voice Messaging Systems
9-47
Programming For Release 2.0 or Earlier 9
To change the VMS Hunt Delay setting for the voice messaging system’s Automated Attendant
service:
1. Press
f00ss#506 at extension 10 or 11.
2. Press
D until the appropriate value appears:
■ Immediate (the factory setting) 
■ Delay
3. Select another procedure, or exit programming mode.
Programming For Release 3.0 or Later 9
To change the VMS Hunt Delay setting for the voice messaging system’s Automated Attendant
service:
1. Press
f00ss#506 at extension 10 or 11.
2. Select Day or Night mode by entering
1 or 2 respectively (the factory setting is 1 = Day).
3. Enter the line number.
The current setting is displayed.
4. To set VMS Hunt Delay, press
D until the appropriate value for the number of rings
appears: 0–6 (2 is the factory setting).
5. To set VMS Hunt Delay for another line, press n or p until the line number
appears on the display. Then repeat Step 4.
6. Select another procedure, or exit programming mode.
VMS Hunt Schedule (#507) 9
Use this feature to determine whether the outside lines assigned to Hunt Group 7 hunt through
the VMS Hunt Group all the time, only during Day operation (Night Service is off), or only during
Night operation (Night Service is on). This feature affects only the Automated Attendant service of
the voice messaging system. For Release 3.0 and later systems, you can program VMS Hunt
Schedule on a per-line basis.
Considerations 9
■ You must use Hunt Group Extensions (#505) to assign the extensions associated with the
voice messaging system hardware to Hunt Group 7.
■ If you set the VMS Hunt Schedule for Day Only or Night Only, you must use Night Service
Button (#503) to program a Night Service Button for extension 10.
■ When the VMS Hunt Schedule is set to Day Only and Night Service is turned off (in Day
mode), calls coming in on lines assigned to the hunt group are sent to the hunt group. If Night
Service is turned on (in Night mode), incoming calls do not go to the hunt group.
■ When the VMS Hunt Schedule is set to Night Only and Night Service is turned off (in Day
mode), calls coming in on lines assigned to the hunt group are not sent to the hunt group. If
Night Service is turned on (in Night mode), incoming calls go to the hunt group.