Avaya PARTNER Advanced Communications System - Set Administration

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Programming a PARTNER System
3-2
■ administer the Direct Inward Dialing (DID) service
■ set the All Lines Busy Event
For instructions on how to install and use PARTNER ACS R6.0 PC Administration, see the
PARTNER
®
ACS R6.0 PC Administration Getting Started.
If you have a T1 module, go to “Configuring the T1 Module” on page 3-9 for instructions on how to
start configuring your PARTNER system.
Set Administration 3
Set Administration enables you to program and administer the features for a PARTNER system
from a system display telephone at extension 10 or extension 11. However, you cannot program
the settings for T1 lines via Set Administration.
The remainder of this guide describes how to program and administer a PARTNER system via Set
Administration.
If your PARTNER system has a T1 module, you must use the PARTNER ACS R6.0 PC
Administration software to program and administer the T1 module. You cannot program a
T1 module via Set administration.