Avaya PARTNER Advanced Communications System - Programming; Using Call Coverage at a System Telephone

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Call Coverage (F20,XX,XX)— Release 2.0 or Later
8-10
Programming 8
To program a Call Coverage button:
1. Press
f00.
2. Press a programmable button, preferably a button with lights.
3. At this point, you can do one of the following:
■ Press f20.
■ Press f20 and the number of the originating extension.
■ Press f20, the number of the originating extension, and the number of the
covering extension.
4. Program another button for this extension, or exit programming mode.
Using Call Coverage at a System Telephone 8
To send calls for coverage manually:
1. Press
f20.
2. Dial your extension number.
3. Dial the extension number of the covering extension.
To remove Call Coverage manually:
1. Press
f20.
2. Dial your extension number twice.
To send calls for coverage by using the programmed button:
1. Press the programmed button.
If an originating extension and a covering extension were programmed on the button, Call
Coverage is activated (on a button with lights, the green light is on). Skip Steps 2 and 3.
2. If no originating extension was programmed, dial your extension number.
3. If no covering extension was programmed, dial the extension number of the covering
extension.
Call Coverage is activated (on a button with lights, the green light is on).
To remove Call Coverage by using the programmed button:
1. Press the programmed button.
If an originating extension and a covering extension were programmed on the button, Call
Coverage is deactivated (on a button with lights, the green light is off). Skip Steps 2 and 3.
2. If no originating extension was programmed, dial your extension number.
3. If no covering extension was programmed, dial your extension number again.
Call Coverage is deactivated (on a button with lights, the green light is off).