PARTNER
®
Advanced Communications System Installation, Programming, and Use
Line Ringing
5-6
Programming 5
To change the way outside lines or pools ring at an extension:
1. Press
f00ssc at extension 10 or 11.
2. Enter the number of the extension to be programmed for Line Ringing.
The green lights next to the line or pool buttons show the current Line Ringing settings for all
lines or pools assigned to the extension. (If a line or pool is not assigned to a button, the green
light next to that button is off.) The following ringing options can be shown by the green light
next to the line or pool button:
■ Immediate Ring — on steady
■ Delayed Ring — flashes slowly
■ No Ring — flutters quickly
3. Press the line
or pool button until the button light shows the correct setting (the setting for the
currently selected line or pool also appears on the display).
4. Continue programming, or exit programming mode.
To Next Page
Loading...
