Using Auxiliary Equipment
Doorphone Programming
9-15
5. If the scanner has an auto answer feature, turn it off.
6. Repeat Steps 1–5 for each additional scanner.
Doorphone Programming 9
When a person uses the doorphone, it signals all alert extensions at the same time. If the alert
extension is a system telephone, the call signals with a unique ding-dong sound to distinguish it
from other calls. If you have two doorphones, they signal with different tones so you can
distinguish between them.
To use the doorphone functionality, program the following features:
■ Doorphone Alert Extensions
■ Doorphone Extension
Doorphone Alert Extensions (#606) 9
Use this feature to identify extensions that are signaled when a doorphone button is pressed.
Considerations 9
■ You cannot bridge two doorphones together.
■ If Do Not Disturb is active at a doorphone alert extension, the person at the doorphone hears
signaling, but the alert extension is not signaled.
■ If a Contact Closure on the Contact Closure Adjunct controls a door lock, consider
assigning the Doorphone Alert Extensions to the Contact Closure Group (#612) for that
Contact Closure. Only extensions assigned to that Contact Closure Group can activate the
door lock.
Programming 9
To identify doorphone alert extensions:
1. Press
f00ss#606 at extension 10 or 11.
2. Enter the first alert system extension number.
3. Press
D until the appropriate value appears:
■ 1 = Not an Alert Extension (the factory setting)
■ 2 = Doorphone 1 Alert Extension
■ 3 = Doorphone 2 Alert Extension
■ 4 = Doorphones 1 and 2 Alert Extension
To Next Page
Loading...
