Overview
6-1
6
Using the Telephones 6
Overview 6
This chapter explains how system and single-line telephones work with the system. The buttons
on the telephones are discussed, as well as the basic call handling features and the display.
System Telephones 6
PARTNER telephones have several buttons and indicators in common. The following pages
explain where they are and how they work. For information about an MLC-6, MLS, or TransTalk
9000-series telephone, see the documentation that came with the telephone.
Buttons and Indicators 6
PARTNER telephones have fixed buttons that are already imprinted and line buttons that you can
press to connect to an inside (intercom) or outside line. If a line button is not assigned as an
intercom or outside line button, you can program an extension number or a feature on it. Some
telephones also have a display, which provides feedback messages and prompts from the system.
Figure 6-1 shows a PARTNER-34D telephone, the largest of the PARTNER telephones.
Endeavor telephones are supported in PARTNER ACS Release 5.0 or later when an
Endeavor 362EC module is installed in the carrier. The Endeavor telephones are
programmed the same as PARTNER-34D -18D, -18, and -6 telephones and have the
same button layouts. For more information about these telephones, see the
documentation that came with the telephones.
To Next Page
Loading...
