Avaya PARTNER Advanced Communications System - Backup Programming-Manual (#124)

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Backup and Restore
4-6
Backup Programming—Manual (#124) 4
Use this feature to manually back up all the programming (except the system date, day, and time)
to a Backup/Restore PC Card.
Programming 4
To begin a manual backup of system settings:
1. Verify that only one Backup/Restore Card is in the processor module.
2. Press
f00ss#124 at extension 10 or 11.
If there is a problem, one of the following messages appears (see Chapter 11,
“Troubleshooting” for explanations and corrective actions):
■ Card is Write Protected
■ Insert Valid Card
■ SystemBusy
If there is no problem, the display instructs you to press Enter to begin the backup.
3. Press
e.
A status message is displayed indicating that a backup is in progress, and within 30 seconds,
a message appears indicating the result.
If the backup was successful, the new backup information replaces the information in the old
MAN.mmddyy file on the Backup/Restore PC Card, and the mmddyy extension now reflects
the current date. Backup information created during a manual backup does not overwrite any
AUTO.mmddyy file.
If the backup failed, you see one of the following error messages (see Chapter 11,
“Troubleshooting” for explanations and corrective actions):
■ Backup Failed:Check Card
■ Backup Failed:SystemBusy
4. Exit programming mode.
If you exit the procedure before the backup finishes, you do not interrupt the backup,
but you do not see feedback messages on the display.