Avaya PARTNER Advanced Communications System - Programming; Using Group Hunting-Ring;Voice Signal on a System Telephone

Programming & Using Telephone Features
Group Hunting—Ring/Voice Signal (I77G/I*77G)
8-43
Programming 8
To program a Hunt Group button:
1. Press
f00.
2. Press a programmable button.
3. Do one of the following:
■ To program the button to ring the next available extension in the Hunt Group, press left
i77 and dial a Hunt Group number (1–8 for ringing calls; 1–7 for voice-signaled
calls).
■ To program the button to voice-signal the next available extension in a Hunt Group, press
left
i*77 and dial a Hunt Group number (1–8 for ringing calls; 1–7 for voice-
signaled calls).
4. Program another button for this extension, or exit programming mode.
Using Group Hunting—Ring/Voice Signal on a
System Telephone 8
To use the programmed button:
■ To ring or voice-signal an extension in the Hunt Group, simply lift the handset or press S,
and press the programmed button. If you are voice-signaling, start talking after the beep.
■ To transfer a call to an extension in the Hunt Group while on a call, press the programmed
button.
To manually ring or voice signal a Hunt Group:
1. Lift the handset and press
i.
You hear intercom dial tone.
2. Do one of the following:
■ To make a ringing call, dial 77 and a group number (1–8).
The next available extension in the Hunt Group rings. If no one answers within three
rings, the call hunts to the next available extension.
■ To make a voice-signaled call, press *77 and a group number (1–8). After the beep,
start talking.
Your voice is heard through the speaker of the first available system telephone that is not
busy. If no one answers, the call does not keep hunting.