Using Auxiliary Equipment
Loudspeaker Paging System
9-27
4. To program another extension, press
n or p until the extension number appears
on the display. Repeat Step 3.
5. Select another procedure, or exit programming mode.
Loudspeaker Paging System 9
Loudspeaker paging systems allow you to broadcast a message over a large area. The system
supports all Avaya paging systems, including the entire PagePac line. The system also supports
most paging systems from other manufacturers when the paging systems are connected using a
paging interface device. Follow these steps to connect a paging system to the processor module
(see Figure 9-11):
1. Insert the modular plug into the PAGE jack on the processor module (located near the middle
of the processor, just above the line jacks).
2. Route the cord through the processor module’s wire manager.
3. Connect the other end of the cord to the paging system.
Figure 9-11. Connecting the Paging System
If you connect a loudspeaker paging system from another manufacturer, a paging
interface may be required.
When you connect a paging system to the PAGE jack, use a two-pair, twisted-pair
cable between the paging system and the processor module.
To Next Page
Loading...
