Avaya PARTNER Advanced Communications System - System Programming Flow Chart-How to Use

E-1
E
Flow Charts E
System Programming Flow Chart—How to Use
To use the following sets of Flow Charts, follow these instructions first:
Place the Programming Overlay on the dial pad of the system display phone at extension 10 or 11.
■ To Start System Programming:
—Press
f00
—Press s s
■ To End System Programming:
—Press
f00
■ To Use a Specific Procedure:
— Dial
# and a three-digit procedure code.
(Example:
#101 for System Date)
■ To Cycle through System Programming Procedures:
—Press
N or P
■ To Cycle Through Available Settings:
—Press
D or d
■ To Return to Factory Setting:
—Press
r
Procedures #399, #609, and #728—shown in dashed boxes—are skipped when cycling
Procedures # 207, #313, #314, and #315—shown in square dotted boxes—are for pools
2.0
3.0
= Factory setting
= Button with lights required
= Button with lights recommended
= PARTNER ACS Revision 2.0 or later
= PARTNER ACS Revision 3.0 or later

Icon Description
6.0
= PARTNER ACS Revision 6.0 or later