PARTNER
®
Advanced Communications System Installation, Programming, and Use
Pool Programming
4-54
Pool Line Assignment (#207) 4
Use this feature to assign lines to or remove lines from the main and auxiliary pools supported for
Hybrid mode. You can change line assignments in the main pool (880) or in any of three auxiliary
pools (881, 882, or 883).
Considerations 4
■ You can assign some or all outside lines to a specific pool, but you cannot assign a specific
outside line to more than one pool.
■ Because users cannot control which line they get when they access a pool, you should group
lines with similar purposes (WATS lines, FX lines, lines designated for a particular set of users)
together in a unique pool.
■ If you have individual lines assigned to a pooled extension and you use this feature to change
pool line assignment, do not press
D or d to specify a pool assignment. If you
do, the system removes that line from all extensions that have the line assigned.
■ You can use Pool Extension Assignment (#314) to assign pools created with this feature to
specific extensions.
■ If you want to prevent a user at an extension from accessing all lines in a specific pool, you
must restrict the extension by using Pool Access Restriction (#315).
Programming 4
To change the assignment of lines to pools:
1. Press
f00ss#207.
2. Enter the first line to be programmed. A display similar to the following appears:
Lines to Pools L08
2 Pool 880
3. Enter the desired value (1–5):
■ 1 = No Pool
■ 2 = Main Pool 880 all lines assigned (the factory setting)
■ 3 = Pool 881
■ 4 = Pool 882
■ 5 = Pool 883
4. To program another line, press
n or p until the line number appears on the
display. Then repeat Step 3.
5. Select another procedure, or exit programming mode.
To Next Page
Loading...
