PARTNER
®
Advanced Communications System Installation, Programming, and Use
Clearing a Backup-Failure Alarm
11-4
Clearing a Backup-Failure Alarm 11
If you use Backup Programming—Automatic (#123) and the automatic backup fails, a Backup-
Failure Alarm message appears (instead of the default day/date/time message) on the top line of
the telephone display at idle extensions 10 and 11.
After correcting the problem that caused the failure, you can clear the Backup-Failure Alarm by
following these steps:
1. Press
f00ss#123.
The current setting appears.
2. Press
3 to choose Option 3, “Backup Alarm Cleared.”
3. Exit programming mode.
012E Module Power Management 11
The power supply used in the 012E module is adequate to power the 12 ETR ports under normal
conditions. However, if too many large PARTNER telephones (such as the PARTNER-34D) are
off-hook with speakerphone volume set to high levels, the power supply could be overloaded.
Power management of the 012E module eliminates the power supply overload.
When a power threshold is exceeded, all telephones connected to the 012E module will appear as
follows:
■ LED display dims to a minimal level
■ Speakerphone volume is decreased
To clear this condition, place one of the telephones connected to the 012E module on-hook. The
LED display and speakerphone volume on all telephones return to normal. If this power
management event occurs frequently, you should consider moving some telephones to available
ports on other modules.
You cannot use D or d in this procedure to choose Option 3.
Using Option 3 to clear a Backup-Failure Alarm does not change the setting for
Backup Programming—Automatic (#123). It remains either Active or Not Active.
To Next Page
Loading...
