Avaya PARTNER Advanced Communications System - Connecting the Contact Closure Adjunct

Using Auxiliary Equipment
Contact Closure Adjunct
9-11
Connecting the Contact Closure Adjunct 9
Follow these steps to connect the Contact Closure Adjunct (see Figure 9-6):
1. Insert the modular plug into the Contact Closure jack, the first jack on the PARTNER ACS
processor module.
2. Route the cord through the processor module’s wire manager.
3. Connect the other end of the cord to the jack in the Contact Closure Adjunct.
4. Have a qualified electrician wire the Contact Closure device or devices (such as an electronic
lock or alert) to the wiring receptacles in the other end of the Contact Closure Adjunct. See the
information shipped with the Contact Closure Adjunct for wiring instructions.
Figure 9-6. Connecting the Contact Closure Adjunct
PARTNER 3000
Contact Closure Adjunct
Contact
Closure Jack
Contact
Closure
Adjunct