Avaya PARTNER Advanced Communications System - Page 364

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Voice Messaging Systems
9-48
Programming For Release 2.0 or Earlier Systems
To change the VMS Hunt Schedule setting for the voice messaging system’s Automated
Attendant Service:
1. Press f00ss#507 at extension 10 or 11.
2. Press
D until the appropriate value appears:
■ 1 = Always (the factory setting) 
■ 2 = Day Only
■ 3 = Night Only
3. Select another procedure, or exit programming mode.
Programming For Release 3.0 or Later 9
To change the VMS Hunt Schedule setting for the voice messaging system’s Automated
Attendant Service:
1. Press
f00ss#507 at extension 10 or 11.
2. Enter the line number.
The current setting is displayed.
3. Press
D until the appropriate value appears:
■ 1 = Always (the factory setting) 
■ 2 = Day Only
■ 3 = Night Only
4. To set VMS Hunt Schedule for another line, press
n or p until the line number
appears on the display. Then repeat Step 3.
5. Select another procedure, or exit programming mode.