PARTNER
®
Advanced Communications System Installation, Programming, and Use
Direct Line Pickup Features
8-34
■ If a line is idle, you cannot access it with this feature (you hear busy tone). For information
about accessing an idle line, see “Direct Line Pickup—Idle Line (I8LL)” on page 8-35.
■ If Line Access Restriction or pool Access Restriction is set to No Access or Out Only for a
line assigned to an extension or lines within a pool, a user at the restricted extension hears
busy tone if Direct Line Pickup is used to answer a call on that line when the line is ringing at
another extension. The user can join a call or access a held or transferred call on the line.
■ You cannot use Direct Line Pickup to access an active call at an extension that has Privacy
activated or that is part of a Conference Call, or to access a held call at an extension that
used Exclusive Hold.
■ Calls picked up with this feature get Caller ID information, unless Line Access Restriction or
Pool Access Restriction is used to prevent users at specific extensions from viewing Caller
ID for ringing calls.
Programming 8
To program a Direct Line Pickup—Active Line button:
1. Press
f00.
2. Press a programmable button.
3. Press left
i68.
4. Program another button for this extension, or exit programming mode.
Using Direct Line Pickup—Active Line on a System
Telephone
8
To use Direct Line Pickup—Active Line on a system telephone:
1. As desired, lift the handset.
2. Do one of the following:
■ Press a button programmed with Direct Line Pickup—Active Line, and dial the two-digit
system line number of the line you want to pick up or join
■ Press i68 and the two-digit line number.
If you did not lift the handset, the speaker comes on automatically.
Using Direct Line Pickup—Active Line on a Single-
Line Telephone
8
To use Direct Line Pickup—Active Line on a single-line telephone:
1. Lift the handset.
You hear intercom dial tone.
2. Dial
68 and the two-digit system line number of the line you want to pick up or join.
To Next Page
Loading...
