41 Adjustment on the device
To select the desired servo frequency, move the rudder stick repeatedly in one direction
until the Status-LED lights in the correct color. Please note that depending on the rudder
servo center pulse width chosen at Menu Point C, you may not be able to select a frequency
higher than 333Hz!
Status-LED Rudder servo frequency
purple 50 Hz
red flashing 165 Hz
red 270 Hz
blue flashing 333 Hz
blue 560 Hz
Note: When you set a different pulse width with StudioXm the Status LED will be off.
You can change back to a preset setting by tapping the rudder stick as described, but this
will remove your custom setting!
95
To Next Page
Loading...
