Beastx MICROBEAST PLUS - Throttle Response (I); Slow Rampup Speed (J)

Slow rampup speed (J)
106.7 Throttle response (I)
Use PARAMETER MENU point I to change the response of the internal Governor control.
This determines how fast and how far the system will open the throttle when the rotor
speed changes. Ideally the response is set as high as possible. If it is too low, the main
rotor will speed up in unloaded conditions as the system reduces throttle not quick enough.
Also the internal Governor will increase throttle very cautious when the rotor is loaded,
so that the head speed will drop. If on the other hand the response is set too high, the
throttle may stutter audible and the throttle will kick in very hard. So the motor speed
will overshoot when the rotor head is loaded. This will make the headspeed even more
inconsistent than with a lower setting. The height of throttle response highly depends on
factors such as heli size (blade size), motor power and performance and/or the throttle
reponse behavior of the speed controller (when flying an electric heli). If you need to
adjust the throttle response, we recommend to start with the lowest value and increase
stepwise just until you get the most consistent rotor head speed. Having a heli with good
motor power and a fast responding speed controller (on electric helis) typically allows to
have high throttle response values (up to ”very aggressive” setting) which will give very
consistent head speed. Helis with not so much power (small nitros, gasser, scale helis)
prefer low throttle response settings for a softer throttle management.
Status-LED Throttle response
off soft
purple normal
red flashing slightly increased
red increased
blue flashing aggressive
blue very aggressive
106.8 Slow rampup speed (J)
When using the internal Governor function this will not apply full throttle immediately
when switching into idle up but will increase the motor speed slowly until the desired head
speed is reached. At menu point J you can determine how fast this soft start occurs when
the Governor is activated initially. The speed is given in number of revolutions by how
much the rotor speed is increased per second. The higher the speed the faster your preset
head speed will be reached. Please note that the given rates only are indicative. Depending
on the response of the speed controller and the inertia of the rotor system it can actually
take longer or shorter until the desired speed is reached.
245