Nitro Governor - simple mode
Rotor speed Governor channel
1820 +10
1680 0
1550 -10
1420 -20
1290 -30
1160 -40
1030 -50
895 -60
760
-70
630 -80
500 -90
off -100
90.3 Nitro Governor - simple mode
If no separate control channel was assigned in RECEIVER MENU for the Governor,
throttle servo and Governor function are solely controlled by the throttle channel. For
this purpose the control range of the throttle channel is divided into two parts: Below
the center position, the throttle servo is controlled manually by the throttle channel. The
Governor is switched off and the servo output range is doubled, so that the throttle servo
can be moved over the entire range. Once the throttle channel is switched to the upper
area, the Governor will activate, spool up the rotor and try to hold the preset headspeed
(the throttle position determines the headspeed here). Similar as it was described above
for electric models you make the throttle curve a horizontal line, so that regardless of
the position of the throttle stick, MICROBEAST PLUS will always see the same throttle
value. So the preset headspeed will stays the same and does not change when moving
throttle stick. At least two flight modes are necessary: One that the throttle curve goes
only up to the middle position and in which the motor can be controlled by hand, i.e. for
starting the motor, and one flight mode in which the throttle curve is a horizontal line
used to preset the desired rotor head speed.
205
To Next Page
Loading...
