53 SETUP MENU H - Servo directions
This page is a translated version
1
of the page Manuals:MBPlusFblV52:Setupmenu H
2
and
the translation is 100% complete.
At SETUP MENU point H move the collective pitch on the transmitter and adjust the
servo directions so that all servos are moving the swashplate up and down together (the
other functions are disabled here, as they are not of interest at this setup step!). After
adjusting servo directions make sure that the pitch direction is correct! You can either do
this by setting the servo directions correctly right from the beginning or by changing the
direction of the pitch channel in the transmitter later.
Please note: Usually you can not reverse the servos with the servo reverse function of
your transmitter! The transmitter only controls the functions of MICROBEAST PLUS,
not the servos! Reversing a channel in the transmitter will only reverse the control
function in total. There is one exception: with mechanical mixing (mCCPM) each
servo is controling one function, so actually here you can reverse the servos be reversing
the sticks/functions in the transmitter, too. Because of this, the servo reversing in
MICROBEAST PLUS is not necessary and not provided when using the mCCPM swash
type! SETUP MENU point H will be skipped in this case.
1
https://wiki.beastx.com/index.php?title=Special:Translate&group=page-Manuals%
3AMBPlusFblV52%3ASetupmenu+H&action=page&filter=&language=en
2
https://wiki.beastx.com/./index.php/Manuals:MBPlusFblV52:Setupmenu_H
121
To Next Page
Loading...
