45 Adjustment on the device
Using the EasySetup adjustment on the device this setup is separated in two Menu Points.
At Menu Point E we set the rudder limits, at Menu Point F we teach the control direction.
At first connect the rudder servo to [CH4] port of MICROBEAST PLUS as described
above now.
45.1 SETUP MENU E - Rudder limits
To adjust the servo limits move the rudder stick in one direction until the servo reaches the
maximum end point without any binding or stall. Release the rudder stick when correct
position is reached. If you moved the servo too far you can steer the stick to the opposite
direction and move the pitch slider a short way back. Also you can tap the stick briefly
to only make minor adjustments. Once the correct endpoint has been found, don‘t move
the rudder stick anymore and wait a second for the Status-LED to flash. This will indicate
that the new position was stored. (If necessary you can change position as often as you
want, but always wait until the Status-LED flashes when finished and proceeding to the
next step!)
Now adjust the opposite direction. For this again use the rudder stick and hold it to move
the servo/tail pitch slider into the other direction. Proceed as described to set the maximum
endpoint and again wait until the position has been indicated with the flashing Status LED.
When both positions have been set skip to the next Menu Point F by pushing the button
on the device briefly.
45.2 SETUP MENU F - Rudder control direction
1. Move the rudder stick and check the rudder direction on the helicopter. If the stick
is moving the servo into the wrong direction use the servo reverse function
of your transmitter and reverse the rudder channel to set stick control direction correctly.
2. Now set the rudder direction of the MICROBEAST PLUS gyro: When you move the
rudder stick to the right, the Status LED must light up or flash in blue color. When you
move the rudder stick to the
left
, the Status LED must light up or flash in
red
color.
When the display is inverted (red = right and blue = left) reverse the display
(internal control direction) by tapping the aileron(!) stick once.
103
To Next Page
Loading...
