23 Receiver Menu
This page is a translated version
1
of the page Manuals:MBPlusFblV52:ReceiverType
2
and
the translation is 100% complete.
Due to the possibility of connecting very different types of receivers with different types of
signal output, you must setup the receiver type in the RECEIVER MENU. Additionally
when using a single-line receiver it is mandatory to define the function assignment for the
receiver output channels. A single-line receiver bundles the control information to data
packages or serialized electical signals. So by default it is not clear, which channel controls
which (stick) function. Finally when using a single-line receiver you have to set a failsafe
position for the throttle channel. This defines at which position the motor is disabled and
where to move the throttle in case the receiver is not sending any throttle signal, i.e. during
power up or in case of loss of radio link.
By default the ”Standard Receiver” is selected as receiver type. So if you're using this
type of receiver and your MICROBEAST PLUS is brand new, you can skip this section
as it is already setup correctly!
1
https://wiki.beastx.com/index.php?title=Special:Translate&group=page-Manuals%
3AMBPlusFblV52%3AReceiverType&action=page&filter=&language=en
2
https://wiki.beastx.com/./index.php/Manuals:MBPlusFblV52:ReceiverType
51
To Next Page
Loading...
