Setup with StudioX
26.2 Function assignment
26.2.1 Default function assignment
Refer to the tables above and identify the column that represents your receiver type.
Check whether your radio transmits the channels in the given order, respectively each
stick function on the radio is using the specified channel number on the left. To know the
channel assignment of your transmitter you can check the user manual of the transmitter
or look at the servo monitor of the transmitter. In order to load the preset assignment
choose Load defaults from the ”New receiver detected!” dialog. Immediately after that
the ”Failsafe” dailog will show up.
26.2.2 Manual function assignment
In case the channel to function ordering differs from the given tables above on your radio
system, you have to manually assign the channel order step by step. This is done by
simply actuating the appropriate channel function on your transmitter at each of the menu
points B to I (PROEDITION: J). Each menu point represents one control function to
assign. When you're ready click Teach in the ”New receiver detected!” dialog and start with
function allocation at Menu Point B. When you move the control stick/change the channel
output on the transmitter, a blue flash of the Status-LED indicates that the channel has
been detected. The setup will jump to the next menu point automatically. It does not
matter how far or in what direction you move the stick or in what position the stick/switch
was. The channel's value itself is not important, but the change of this value is. It is
therefore important that only the requested function is activated and not by
accident several simultaneously! Otherwise MICROBEAST PLUS may not recognize
the allocated channel correctly. Once a channel was assigned, it is no longer available and
is ignored by MICROBEAST PLUS for the remaining process. Thus, after learning of the
collective pitch function (at Menu Point B) you can enable the throttle function (remove
throttle hold or switch to a linear or V shape curve) and teach the throttle channel by
re-operating the thrust stick at Menu Point G. Now the collective pitch channel is no longer
considered as this channel has already been assigned previously and MICROBEAST PLUS
will detect and use the throttle channel as actuator for throttle function!
Choose Teach
At first move the stick for collective. Make sure only one channel is moved on the radio
otherwise MICROBEAST PLUS is not able to detect the movement!
Proceed with the other function in similar manner
The optional functions can be skipped if not needed. See text below!
When skipping the channel number will be shown as -
62
To Next Page
Loading...
