Beastx MICROBEAST PLUS - 95 Adjustment on the Device

95 Adjustment on the device
To set the gear ratio on the device you have to adjust three menu points in a row. Menu
point F sets the number of gear ratio before the decimal point, menu points G and H
specify the first two decimal places. Compare the following table and set the Status-LED
using the rudder stick to the corresponding color and condition at each menu point so the
desired gear ratio will result as a combination of all three menu points (X.YZ:1). The
ratio can be adjusted in increments of 0.05. Choose the ratio that is the closest for your
helicopter and set the menu points one after the other. To proceed to the each menu point
briefly push the button. After menu point H the initial setup is finished and the button
press will lead back to operation mode.
Menu point F
Status-LED
X.
off user defined
purple flashing 8
purple 9
red flashing 10
red 11
blue flashing 12
blue 13
red/blue 14
Menu point G
Status-LED
.YZ Menu point H
Status-LED
purple flashing .00 purple flashing
purple flashing .05 purple
purple flashing .10 red flashing
purple flashing .15 red
purple .20 purple flashing
purple .25 purple
purple .30 red flashing
purple .35 red
red flashing .40 purple flashing
red flashing .45 purple
red flashing .50 red flashing
red flashing .55 red
red .60 purple flashing
red .65 purple
red .70 red flashing
red .75 red
217