EasyManua.ls Logo

Beastx MICROBEAST PLUS - 7 Safety Notes

Beastx MICROBEAST PLUS
353 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7 Safety Notes
This page is a translated version
1
of the page Manuals:MBPlusFblV52:Safety
2
and the
translation is 100% complete.
Radio controlled (R/C) helicopters are no toys! The rotor blades rotate at high
speed and pose potential risk. They may cause severe injury due to improper usage.
It is necessary to observe common safety rules for R/C models and the local law. You
can gather information from your local R/C model club or from your national modelers
association.
Pay attention to your own safety and the safety of other people and property in
your vicinity when using our product. Always fly in areas away from other people.
Never use R/C models in close proximity to housing areas or crowds of people.
R/C models may malfunction or crash due to several reasons like piloting mistakes
or radio interference, and cause severe accidents. Pilots are fully responsible for their
actions, and for damage or injuries caused by the usage of their models.
Please read the instruction manual thoroughly before the first use of your
MICROBEAST PLUS and setup the system carefully according to this manual. Allow
sufficient time for the setup procedure and check each step carefully. Watch for a
mechanically clean and proper build of your helicopter. A wrong system setup can lead
to a serious accident and damage to the model.
Radio controlled (R/C) models consist of several electrical components. It
is therefore necessary to protect the model from moisture and other foreign sub-
tances. If the model is exposed to moisture this may lead to a malfunction which may
cause damage to the model or a crash. Never fly in the rain or extremely high humidity.
When operating the helicopter with a MICROBEAST PLUS ensure there is a
sufficiently large and stable receiver power supply. Because of the direct coupling of
the rotor blades to the servos, without the use of a flybar mixer, the servos are exposed
1
https://wiki.beastx.com/index.php?title=Special:Translate&group=page-Manuals%
3AMBPlusFblV52%3ASafety&action=page&filter=&language=en
2
https://wiki.beastx.com/./index.php/Manuals:MBPlusFblV52:Safety
15

Table of Contents

Other manuals for Beastx MICROBEAST PLUS

Related product manuals