114 Adjustment at the device
If not already done enter PARAMETER MENU by pushing the button briefly when
the device is operational, so that the Menu LED next to point A starts to flash. Then
repeatedly press the button to skip to Menu LED (menu point) L. At PARAMETER
MENU point L you can choose between five different AttitudeControl operation modes.
This is done by selection with the rudder stick. Tap the rudder stick repeatedly until the
Status-LED lights in the desired color. If one of the AttitudeControl operation modes is
selected, the AttitudeControl function is enabled and it can be activated/deactivated in
operation by using the previously assigned transmitter channel for AttitudeControl. The
”AttitudeControl disabled” option specifies the AttitudeControl is completely disabled and
actuating the AttitudeControl channel has no effect (in terms of the AttitudeControl).
The assignment to the colors of the Status-LED is as follows:
Status-LED AttitudeControl operation mode
off AttitudeControl disabled
purple Angular Mode
red flashing Bail out rescue mode
red Bail out rescue mode with pitch
blue flashing 3D - Mode
blue 3D - Mode with pitch
Firstly enable AttitudeControl when all initial settings in SETUP MENU and
RECEIVER MENU have been performed. Otherwise the servos may drive to the me-
chanical full stop, start binding and may get damaged, e.g. when AttitudeControl gets
activated when leaving the menu and the system starts to try moving the heli.
Briefly press the button store the setting. In case you've chosen a mode with (collective)
pitch control, briefly pressing the button at point L will lead to menu point M. Otherwise
menu point M will be skipped und the system will exit PARAMETER MENU.
273
To Next Page
Loading...
