37 SETUP MENU C - Rudder pulse
width
This page is a translated version
1
of the page Manuals:MBPlusFblV52:Setupmenu C
2
and
the translation is 100% complete.
With Setup menu point C you define the (center) pulse width for the rudder servo. Almost
all available rc servos work with 1500 - 1520 μs. But there are a few special rudder servos
on the market which use a different center position pulse length.
Figure 93
Here
3
you can find a list of parameters for the most common servos. Please understand
that we can not list all servo types. If a servo needs a special pulse length this usually is
mentioned in the data sheet of the servo, mentioned on the packaging or directly printed on
the servo. Ask the manufacturer of the servos or your local dealer for detailed information.
If in doubt about the center pulse for your servo use the setting 1520 μs. It is very likely
that the servo will work with this pulse length. Also when the servo is rated with 1500
μs center pulse use this setting. There is barely any difference between 1500 and 1520
1
https://wiki.beastx.com/index.php?title=Special:Translate&group=page-Manuals%
3AMBPlusFblV52%3ASetupmenu+C&action=page&filter=&language=en
2
https://wiki.beastx.com/./index.php/Manuals:MBPlusFblV52:Setupmenu_C
3
https://wiki.beastx.com/./index.php/The_BEASTX_servo_list/en
87
To Next Page
Loading...
