99 Adjustment with StudioX
When StudioX has connected to your MICROBEAST PLUS, in the device overview
main screen click the ”Parameter” button. The topic ”Quick Trim” provides adjustment
buttons to change the trim values for aileron, elevator, rudder and also collective.
Positive values indicate the directions right, forward or up. Negative values indicate
left, backwards or down. Please note that the first screen ”Quick trim” has global
effect, meaning that the values set here are used in all of the Paramter Banks (in case
you're using the Bank Switching feature). Separate trimming for each bank is not provided.
On the bottom of the screen you can see the trimming for the Artificial Horizon. Here you
can trim the tilt on the roll and pitch axis in steps of 0.5 degrees. Please read the notes
above for more information about this feature.
225
To Next Page
Loading...
