105 Setup with StudioX
Please note that editing parameters is only possible when the device has initialized
completely. So as long as the system is not in operation mode the button to open
the ”Parameters” section is greyed out. If it does not pass initialization sequence check
the device status shown in the middle of the screen. If the system does not finish
”Receiver init” check the receiver settings and radio setup. If the system does not fin-
ish ”Sensor init” make sure that it is perfectly standing still and that power supply is stable.
Click the ”Parameters” button. You will find the special parameters mentioned above
under ”Bank 1 - Parameters”. You can edit them using the given adjustment buttons.
When using the bank switching feature (only with PROEDITION firmware) you can set
parameters for banks 2 and 3 accordingly and switch between those different settings in
flight. When bank switching is deactivated you can only set parameters for bank 1 as this
is the default bank.
237
To Next Page
Loading...
