46 Setup with StudioXm
1. When you move the rudder stick to full deflection, the Status LED on the MI-
CROBEAST PLUS should light solid and the label right or left should change the color
accordingly. If the stick is not moving far enough, you will see the message ”Increase!”
In this case increase the servo throw/endpoint of the rudder channel in the
transmitter just as far so that the Status LED changes from flashing to solid
when the rudder stick reaches the end position and the label will disappear in the
software. Repeat this for the other direction. Note: Do not increase the endpoint too much
in the transmitter. We need an exact match of full stick position and stick end position.
So the Status LED should just change from flashing to solid when raching the end position.
Stick moved into one direction, deflection not enough
Stick moved into one direction, maximum position reached
2. Now connect the rudder servo to [CH4] port of MICROBEAST PLUS as described
above and check the rudder direction on the helicopter. If the stick is moving the servo
into the wrong direction use the servo reverse function of your transmitter and
reverse the rudder channel to set stick control direction correctly. Now when the servo is
moving correctly set the rudder direction of the MICROBEAST PLUS gyro: When you
move the rudder stick/servo to the right, the Status LED must light up or flash in blue
color. When you move the rudder stick to the left, the Status LED must light up or flash
in red color. When the display is inverted (red = right and blue = left), reverse
the display (internal control direction) by choosing either normal or inverted
in the software.
Stick moved left, but label shows right
Stick moved left, label shows left
3. Finally adjust the servo limit by changing the values in the two adjustment boxes for
each direction. To do so, carefully use the rudder stick to move the servo to the endpoint
(watch out to not jam the servo) and increase/decrease the endpoint as necessary.
105
To Next Page
Loading...
