Beastx MICROBEAST PLUS - 97 PARAMETER MENU a - Quick Trim

97 PARAMETER MENU A - Quick
Trim
This page is a translated version
1
of the page Manuals:MBPlusFblV52:Quicktrim
2
and the
translation is 100% complete.
The first menu point of the PARAMETER MENU gives you the possibility to quickly
adjust swashplate and rudder trim on the flying field. This may be neccessary when your
helicopter slowly drifts in hovering flight or when it doesn’t climb out straight on sudden
collective pitch inputs. Additionaly when using the AttitudeControl feature (only included
in PROEDITION firmware upgrade) you may trim the reference point of the artificial
horizon in case the heli does not level perfectly when AttitudeControl stabilization is active.
Please note that the Quick Trim is a global parameter. When you use the Bank
Switching feature the values you set here will be used in any flight mode. Separate
trimming for each flight mode is not provided as we think it's not necessary.
Never use the trim functions of your remote control! MICROBEAST PLUS
will see trim as a control command to turn the heli and not as servo trim. So using the
trim on your transmitter will result in a constant rotational movement (if you feel you
have such effect even when sticks are perfectly centered and all trims are zero, it may
be necessary to increase the Stick Deadband at PARAMETER MENU point E!)
1
https://wiki.beastx.com/index.php?title=Special:Translate&group=page-Manuals%
3AMBPlusFblV52%3AQuicktrim&action=page&filter=&language=en
2
https://wiki.beastx.com/./index.php/Manuals:MBPlusFblV52:Quicktrim
221