Adjustment on the device
receiver detection routine. The Status-LED will indicate which type the system is scanning
for at the moment. When a valid input signal was detected the receiver type will be set
automatically and the system will skip to Menu Point B in case a single-line receiver is
used or it will exit and restart when a Standard receiver is used. When detection failed,
the system will stay at menu point a and the Status LED will flash in red color. In this
case once again make sure your receiver is connected properly to MICROBEAST PLUS,
bound to the transmitter and sending out control signals and try again.
Status-LED Receiver type/Transmission protocol
off Standard receiver
purple Remote satellite/receiver connected at remote port
red No receiver detected
blue Serial signal at port DI1
25.2 Function assignment
25.2.1 Default function assignment
Refer to the tables above and identify the column that represents your receiver type.
Check whether your radio transmits the channels in the given order, respectively each
stick function on the radio is using the specified channel number on the left. To know the
channel assignment of your transmitter you can check the user manual of the transmitter
or look at the servo monitor of the transmitter. In order to load the preset channel
assignment hold down the button for at least 2 seconds and release. The yellow Menu-LED
will immediately jump to Menu Point N.
56
To Next Page
Loading...
