Function assignment
Figure 73
25.2.2 Manual function assignment
In case the channel to function ordering differs from the given tables above on your radio
system, you have to manually assign the channel order step by step. This is done by simply
actuating the appropriate channel function on your transmitter at each of the menu points B
to I (PROEDITION: J). Each menu point represents one control function to assign. When
you move the control stick/adjust the channel with the transmitter, a blue flash of the
Status-LED indicates that a channel has been detected. It does not matter how far or in
what direction you move the stick or in what position the stick/switch was. The channels
value itself is not important, but the change of this value is. It is therefore important
that only the requested function is activated and not by accident several simultaneously.
Otherwise MICROBEAST PLUS may not recognize the allocated channel correctly. If you
have moved the wrong stick/switch, just move the correct one afterwards. MICROBEAST
PLUS remembers only the last function that was operated and confirms it with blue flashing
of the Status-LED.
Press the button after learning each function to save the assignment and to go to the
next function. Once a channel was assigned, it is no longer available and is ignored by
MICROBEAST PLUS for the remaining process. Thus, after learning of the collective
pitch function (at Menu Point B) you can enable the throttle function (remove throttle
hold or switch to a linear or V shape curve) and teach the throttle channel by re-operating
the thrust stick at Menu Point G. Now the collective pitch channel is no longer considered
as this channel has already been assigned previously and MICROBEAST PLUS will detect
and use the throttle channel as actuator for throttle function!</p>
The first 6 functions must be assigned as they are necessary for the basic flight control and
the button remains locked until you operate a new control function. The other functions are
57
To Next Page
Loading...
