43 Manuals:MBPlusFblV52:Setupmenu
E
This page is a translated version
1
of the page Manuals:MBPlusFblV52:Setupmenu E
2
and
the translation is 100% complete.
Next we have to setup the rudder gyro. For this we set the limits of the tail pitch control
and the control directions, so the gyro will not move the servo further than allowed and in
correct direction. In first line the rudder limits are necessary to prevent the gyro from mov-
ing the servo over the mechanical limits and damaging the servo. But when adjusting the
limits please note that the optimum throw is not necessarily determined by the maximum
possible control travel of the tail pitch slider. When the tail mechanics allow a very high
range of pitch it may be advisable to adjust the limits based on the maximum allowed angle
of attack of the tail rotor blades that will not lead to an aerodynamic stall of the blades.
Such stalls can cause very bad stopping behavior like overshooting of the tail when stopping
from rotation and can also cause bad tail response to rudder stick input when performing
directional changes. Keep this in mind when adjusting the tail rotor endpoints. Check
the helicopter‘s manual to find out how much tail pitch is useful and where to set end points.
1
https://wiki.beastx.com/index.php?title=Special:Translate&group=page-Manuals%
3AMBPlusFblV52%3ASetupmenu+E&action=page&filter=&language=en
2
https://wiki.beastx.com/./index.php/Manuals:MBPlusFblV52:Setupmenu_E
99
To Next Page
Loading...
